Electrician in Springvale South, Melbourne's South East

Breaker tripping, power boards on every bench, an old fuse box in the hall? A Springvale South electrician can bring a 1960s or 1970s house up to date, from the switchboard to the power points.

Electrician in Springvale South, Melbourne's South East

Tell us about your project

Let us know about the electrical work and we'll send you a quote.

Include access and anything nearby that affects the job.

See our privacy policy.

A licensed electrician in Springvale South can bring an older house up to date by replacing a worn switchboard, fitting safety switches, rewiring tired circuits and adding power points where you use them. Much of the housing here went up in the 1960s and 1970s, when homes were wired for far fewer appliances than a family runs today. The aim is a safer house that copes with modern loads, with a quote to weigh before you agree to the work.

Services in Springvale South

Electricians in Springvale South: rewiring, safety switches and upgrades

Three jobs cover most of what an older house needs. A switchboard upgrade replaces old fuses or an outdated board with a modern one. A safety switch fit adds earth-leakage protection to circuits that run without it today. Rewiring replaces cabling that has aged, been damaged or cannot carry the load of a modern household.

After inspecting the board and testing the circuits, the electrician tells you which of the three the house needs. Cable and a board that test sound can stay where they are. If wiring has to be replaced, you hear why.

Extra power points are the upgrade people notice most. A kitchen with one double outlet and a power board behind the bench points to a house wired for another era. A good plan puts outlets where the toaster, the desk and the phone chargers actually sit.

A split system air conditioner fits neatly into a board upgrade. It needs a circuit of its own, and an older board often has no spare room for one, so adding it while the board is being replaced is the easiest time to do it.

What does rewiring an older house involve?

Rewiring means running new cable from the switchboard to the power points, lights and appliances, then connecting it all to the new board. Old cable is taken out of service so it cannot be used by mistake.

The electrician decides on site whether the whole house needs it or only some circuits. Wiring that is brittle, scorched or overloaded is a reason to replace it. Cable that tests well may stay.

Tradespeople work through the roof space and wall cavities, and a careful one protects your ceilings and keeps the mess down. Patching plaster is usually a separate job, so it helps to know that before the quote is agreed.

A rewire is signed off on a Certificate of Electrical Safety that covers the new circuits, which helps when the house is later sold or leased.

A new switchboard, or only safety switches?

Sometimes a safety switch is all the board needs. If the board is sound and has room, the electrician can fit protection to the circuits you use most. If it still has ceramic fuses, is crowded or shows heat damage, replacing the whole board makes more sense.

That is how you tell good advice from an upsell. You should hear what the board needs and what it does not, with the reasoning, before you agree to anything.

A quote agreed before work starts covers the scope the electrician has described. That gives you a price to weigh against the safety gain.

A power outage or burning smell at home in Springvale South

In a 1960s or 1970s house, a section that goes dead and will not reset often traces to an overloaded original circuit or a faulty appliance on it. Switch off what was running, leave the breaker alone after one reset and let an electrician find the fault.

A burning smell or scorching at a power point or switch in a Springvale South house is more serious. Stop using that outlet. Call 000 if there is smoke or flames.

These are not fixes to try yourself. A power point that has overheated can have damaged wiring behind it that only testing will reveal.

Springvale South streets and the homes on them

Springvale South sits between Springvale and Keysborough and was subdivided for housing in the 1960s and 1970s. A house from the subdivision years may still carry its original switchboard, ceramic fuses and only a couple of outlets per room. Add a modern kitchen, a split system and a home office to that older wiring and the board is under strain.

The sandy soil here once suited large poultry farms, until housing spread out from Springvale and most farms retreated further into the sandbelt. The houses that replaced them are the ones now asking for updated boards and extra circuits.

Under a modern load, an old board tends to show it first as a fuse that blows or a breaker that trips when the kettle and a heater run together.

Residential streets between Springvale South Shopping Village, Athol Road Primary School and Spring Valley Reserve are laid out to keep through traffic out. That usually means a quiet kerb for the electrician's van during a board change.

Extensions are where old and new wiring meet. A back room added to an older house can have a newer circuit feeding off the original fuse board, and the electrician sorts this out when tracing circuits.

If one of these houses is a rental, the electrical safety check is a good reason to look at the board and the older circuits sooner rather than later.

Frequently Asked Questions

Will the electrician arrange the permits for a job in Springvale South?

A licensed electrician handles the electrical paperwork for installation work, so you do not chase it yourself. A bigger renovation may need a building permit, which a registered building surveyor issues as a separate step from the electrical work. Your quote states what the electrical scope covers.

Get it priced

Breaker tripping or a power point gone dead? Tell us what is happening and get it sorted.

Let us know about the electrical work and we'll send you a quote.